Zero Differential - 2 Way Normally Closed

878X Solenoid Valves

UL Listed
PEI Member

The 878X is a Heavy Duty two way normally closed, one directional flow, direct lift solenoid valve with threaded or flange connections.

The valve opens when energized and it does not need pressure to operate, meaning that the valve fully opens with zero pressure in the line. It is Ideal for gravity fed applications.

The piston assembly makes it possible to deliver more flow compared to diaphragm valves.

Compatible for use with a number of fluids, like fuel, diesel, gasoline, bio-fuels, ethanol, oil, gasoil, cold and hot water, air, steam, gases, and any other petroleum derivatives.

  • Zero Differential – Direct Lift
  • Pressure Relief Built in the Valve
  • Industrial Grade Piston with Viton, Teflon, Buna N, or EPDM Seats
  • Heavy Duty Cast Bronze or Investment Cast Stainless Steel 316 Body
  • Higher Flow than Diaphragm Valves
  • Longer service life than Diaprhagm Valves
  • Explosion Proof Housing meet UL, CSA and ATEX
  • Minimum Ambient Temperature -42F
  • Female Threaded NPT or Flange Class 150 Connections

Viton

Fuel, Diesel, Gasoline, Jet Fuel, Kerosene, Oil, and other Petroleum Derivatives

Teflon

Fuel, Diesel, Gasoline, Jet Fuel, Kerosene, Oil, Petroleum Derivates, Biodiesel, Steam, DEF

EPDM

Hot Water, Low Pressure Steam, DEF

Buna N

Water, Air, Gas

Flange Connections:

SizeTypeBody MaterialSeat MaterialMax Fluid Temp FMin Diff Pressure PsiMax Diff Pressure PsiModel #hf:tax:connection_sizehf:tax:bodyhf:tax:seat_material

Important Installation Instructions

A strainer or filter (100 microns) should always be installed as close as possible to the inlet of the solenoid valve. Valve must be mounted on horizontal pipe with coil vertical and upright.

Standard Voltage:24, 120, 208, 240 and 480 volts AC60Hz or 110 and 220 AC50Hz
12, 24, 48, 110 volts DC (3” DC not available)
Must be specified when ordering. Add voltage to the end of the Catalog Number. For example: 2CN-16XXRVZ-878X-120/60


Table is for 3/4” to 2” valves (3” Valves draw approx. 60% more amps)

Wetted Parts

PartMaterial
BodyBronze or Stainless Steel 316
PistonBrass(*) or Stainless Steel 316
SeatViton, Teflon, Buna N, or EPDM
SealsViton, Teflon, Buna N, or EPDM
Core TubeSS 316L
CoreSS 430

* Aluminum in 3″ Valve

Flange Connections Valve Dimensions (in.)